NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Electrical Brake Control Unit

Nissan Armada 2025-2026 Service and Repair Manual / Brakes / Brake System / Additional Service When Replacing Electrical Brake Control Unit

Work Procedure

Description

When replacing the electrical brake control unit, the procedures of AFTER REPLACEMENT must be performed.

CAUTION:

If the electrical brake control unit is undamaged, do not decide to replace it based on DTC detected in the past.

AFTER REPLACEMENT

After replacing the electrical brake control unit, the following items must be performed:

  • Electrical brake control unit programming

  • Air bleeding of brake fluid

Work Procedure (After Replace Electrical Brake Control Unit)

PERFORM ELECTRICAL BRAKE CONTROL UNIT PROGRAMMING

With CONSULT

Perform electrical brake control unit programming, according to “Programming” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.

CAUTION:

During programming, maintain the following conditions:

  • Ignition switch: ON

  • Electric parking brake: Apply (Models with electric parking brake function)

  • Electric load: OFF

  • Brake pedal: Not depressed

  • 12V battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

>>

GO TO 2.

PERFORM NECESSARY WORK

With CONSULT

  1. Perform air bleeding. Refer to Bleeding Brake System.

  2. Perform stroke sensor calibration. Refer to Work Procedure.

  3. Perform self-diagnosis for “All DTC Reading”.

  4. Erase the memory of self-diagnosis results.

>>

End of work.

    Other materials

    Rear Blower Motor
    Exploded View Rear A/C unit assembly Rear blower motor     : vehicle front Removal and Installation REMOVALRemove rear A/C unit assembly. Refer to Removal and Installation. Disconnect rear blower unit harness connector. Remove fixing screws , and then remove rear blower motor. ...

    Steering Tilt
    Diagnosis Procedure CHECK MANUAL OPERATION Check manual operation. Does it operate normally? YES>> GO TO 2. NO>> Refer to Diagnosis Procedure. CHECK TILT SENSOR Check tilt sensor LH. Refer to Component Function Check. Is the inspection result normal? YES>> Check intermittent inc ...

    The Fuel Gauge Indicator Does Not Operate
    Diagnosis Procedure Fuel gauge will not indicate from a certain position.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to On Board Diagnosis Function. Is the inspection result no ...