Inspection and Adjustment
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
INSPECTION
Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary.
| Wear thickness | : Refer to Rear Disc Brake. |
ADJUSTMENT
Burnish contact surfaces between disc rotor and brake pads according to the following procedure after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage.
CAUTION:
-
Be careful of vehicle speed because the brake does not operate firmly/securely until pads and disc rotor are securely fitted.
-
Only perform this procedure under safe road and traffic conditions. Use extreme caution.
Drive vehicle on straight, flat road.
Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops.
Drive without depressing brake for a few minutes to cool the brake.
Repeat steps 1 to 3 until pad and disc rotor are securely fitted.
Other materials
Wiper and washer switch
Basic information
WARNING
In the Nissan Armada, using the washer system in freezing temperatures may
cause the fluid to freeze on the windshield, significantly reducing visibility.
Always warm the glass using the defroster before activating the washer system to
ensure safe driving conditions ...
2wd Tools and Preparation
Preparation
Commercial Service Tool
Tool name Description
Power tool
Loosening bolts and nuts
Ball joint remover
Removing hub bolt
Removing steering outer socket
...
Body Side Trim
Exploded View
Rear body side welt
Assist grip
Center pillar upper garnish
Front body side welt
Front pillar garnish
Assist grip
Front kicking plate
Dash trim clip
Dash side finisher
Harness protector
Front side bracket
Center pillar lower garnish
Center pill ...