Exploded View
 |
Front output shaft |  |
Front oil seal |  |
Front case |
 |
Snap ring |  |
Sprockets with chain |  |
Snap ring |
 |
Rear case |  |
Rear companion flange |  |
O-ring |
 |
: Always replace after every disassembly. | ||||
 |
: N·m (kg-m, ft-lb) | ||||
 |
: Apply transfer fluid. | ||||
 |
: Apply Genuine Liquid Gasket, Loctite 598 or equivalent. | ||||
Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Drain transfer fluid. Refer to Draining.
Remove transfer assembly from vehicle. Refer to Removal and Installation.
Remove the rear companion flange and remove the o-ring.
Remove the rear case mounting bolts 
.
| * | : Tighten together with the bracket. |
Remove the rear case .
Remove the rear output shaft snap ring .
Remove the sprockets with chain from front case .
Remove the front output shaft snap ring .
Remove the front output shaft from front case .
CAUTION:
Never damage the output shaft.
Remove the front oil seal form front case .
CAUTION:
Never damage the front case.
INSTALLATION
Install front oil seal with a drift (A) (commercial service tool) within the dimension (L) shown as follows.
| L | : 1.7 – 2.3 mm (0.067 – 0.091 in) |
CAUTION:
-
Never reuse front oil seal.
-
Apply transfer fluid onto circumference of oil seal.
-
When installing, never incline front oil seal.
-
Never handle the oil seal inner periphery and oil seal lip.
Install the front output shaft to front case .
CAUTION:
Never damage the front oil seal lip.
Install the front output shaft snap ring .
Install the sprockets with chain to front case .
Install the rear output shaft snap ring .
Apply sealant to mating surface of rear case.
-
For applying sealant, refer to Exploded View.
Install the rear case .
Tightening the rear case mounting bolts to the specified torque. Refer to Exploded View.
| * | : Tightening the bolt with bracket. |
Install the o-ring and install the rear companion flange .
Install transfer assembly. Refer to Removal and Installation.
Fill with new transfer fluid. Refer to Refilling.
Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
When transfer case component parts are removed, performe writing unit parameter. Refer to Description.
Other materials
System operation
The Nissan Armada sonar system provides both visual and audible alerts under
the following conditions:
Detection of front obstacles when the transmission is in D (Drive)
Detection of both front and rear obstacles when the transmission is in R
(Reverse)
How the system alerts of obstacle ...
Front Door Regulator
Exploded View
Front door regulator assembly is assembled on front door module assembly. Refer to Exploded View.
Removal and Installation
Front door regulator assembly is assembled on front door module assembly. If you need replace front door regulator, refer to Removal and Installation.
Disassembly ...
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...