Nissan Armada 2025-2026 Service and Repair Manual: Inspection and Adjustment
WARNING:
INSPECTION
Appearance
2WD: Refer to Removal and Installation.
4WD: Refer to Removal and Installation.
Runout
Check the wheel bearing axial end play.
2WD: Refer to Inspection.
4WD: Refer to Inspection.
| Runout (with it attached to the vehicle) | : Refer to Front Disc Brake. |
CAUTION:
2WD: Refer to Removal and Installation.
4WD: Refer to Removal and Installation.
| Wear thickness | : Refer to Front Disc Brake. |
Thickness
2WD: Refer to Removal and Installation.
4WD: Refer to Removal and Installation.
| Wear thickness | : Refer to Front Disc Brake. |
ADJUSTMENT
CAUTION:
Drive vehicle on straight, flat road.
Drive without depressing brake for a few minutes to cool the brake.
Repeat steps 1 to 3 until pad and disc rotor are securely fitted.
Disc Rotor
...
Front Disc Brake
Unit: mm (in)
Item Limit Brake pad Wear thickness 2.0 (0.079) Disc rotor Wear thickness 27.4 (1.079) Thickness variation (measured at 8 positions)* 0.006 (0.0002) Runout (with it attached t ...
Other materials:
Work Procedure
CHOOSE METHOD
There are two ways of initialization method.
Which method do you choose?
With CONSULT>>
GO TO 2.
Without CONSULT>>
GO TO 3.
WITH CONSULT
With CONSULT
Ignition switch ON.Perform "Third seat RH position initialization" in "Work support" mode of "THIRD SEAT RH" using CONSUL ...
Draining
WARNING:
Start the engine and let it run to warm up transmission.
Stop the engine.
Lift up the vehicle.
When the oil pan positioning mark is difficult to find, mark it with paint or like beforehand.
Remove the drain plug to allow fluid to drain using OFT position change wrench (SST: NI-52972–2) ...
Multiport Fuel Injection System or Engine Control System
Before connecting or disconnecting any harness connector for the multiport fuel injection system or ECM:
Turn ignition switch to “OFF” position.
Disconnect negative battery terminal.
Otherwise, there may be damage to ECM.
Before disconnecting pressurized fuel line from fuel pump to injectors, b ...
0.0058