Nissan Armada 2025-2026 Service and Repair Manual: Precautions for Harness Repair
Solder the repaired area and wrap tape around the soldered area.
NOTE:A fray of twisted lines must be within 110 mm (4.33 in).
Bypass connection is never allowed at the repaired area.
NOTE:Bypass connection may cause CAN communication error. The spliced wire becomes separated and the characteristics of twisted line are lost.
Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communication line.
Precaution for Brake Control System
Always perform a pre-driving check to drive the vehicle.
Always check speed and safety while driving the vehicle.
To operate CONSULT while driving, more than one person is required to be in the vehicl ...
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
System
WARNING:
CAUTION:
OPERATION PROCEDURE
Jacking up or lift up using the following steps.
Start engine.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Jacking up or lif ...
Other materials:
Removal and Installation
CAUTION:
Always work with a helper.
When removing/installing moonroof unit assembly, use cloths to protect the seats and trim from damage.
REMOVAL
Remove wind deflector. Refer to Removal and Installation.
Remove glass lid. Refer to Removal and Installation.
Remove headlining. Refer to Removal and I ...
Removal and Installation
REMOVAL
Remove driver air bag module. Refer to Removal & Installation.
Remove steering wheel. Refer to Removal and Installation.
Remove steering column cover upper and lower. Refer to Removal and Installation.
Disconnect spiral cable body side harness connectors .
Left side
: Vehicle front
...
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
GET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK DTC
Check DT ...
0.0066