
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the driver side door opened.
Get out of the vehicle and close the driver side door.
| BR08DE | : 4 minutes | R9N engine | : 12 minutes |
| BR10DE | : 12 minutes | V9X engine | : 4 minutes |
| D4D engine | : 20 minutes | YD25DDTi | : 2 minutes |
| HR09DET | : 12 minutes | YS23DDT | : 4 minutes |
| HR10DDT | : 12 minutes | YS23DDTT | : 4 minutes |
| HR10DET | : 12 minutes | ZD30DDTi | : 60 seconds |
| HR13DDT | : 12 minutes | ZD30DDTT | : 60 seconds |
| HRA2DDT | : 12 minutes | K9K engine | : 4 minutes |
| M9R engine | : 4 minutes | R9M engine | : 4 minutes |
CAUTION:
Remove 12V battery terminal.
CAUTION:
Precaution for when Jacking and Lifting Up the Vehicle with Electronic Air Suspension
SystemWork Procedure
VIN Registration is an operation to register the VIN in ADAS control unit.
CHECK VIN
Check VIN of vehicle and note it. For VIN stamped position, refer to Information About Identification or Model Code .
>>
GO TO 2 .
PERFORM VIN REGISTRATION
With CONSULT
Ignition switch ON.
CAUTION:
Never s ...
Bulb Specifications
Item Type Wattage (W) Front combination lamp Headlamp (Hi) LED — Headlamp (Lo) LED — Parking lamp/Daytime running light/Front turn signal lamp LED — Front side marker lamp LED — Front fog lamp LED — Side turn signal lamp LED — Rear combination lamp Tail lamp/Stop ...
Inspection
WARNING:
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
CAUTION:
The ignition switch OFF while checking oil level.
Oil level should be level with bottom of filler plug hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug ...