AV COMMUNICATION SYSTEM
Do not apply voltage of 7.0 V or higher to the measurement terminals.
Use the tester with its open terminal voltage being 7.0 V or less.
Be sure to turn ignition switch OFF and disconnect the battery cable from the negative terminal before checking the circuit.
PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
PRECAUTIONS FOR HARNESS REPAIR : PrecautionsWork Procedure
CHECK CAMERA LENS AND WINDSHIELD
Are camera lens and windshield contaminated with foreign materials?
YES (When the camera lens is contaminated with foreign materials.)>>
Replace front camera unit 【Refer to Removal and Installation (Without ProPILOT Assist 2.1) or Removal and Installation (W ...
Diagnosis Procedure
CHECK TELEMATICS SYSTEM SYMPTOM TABLE
Check telematics system symptom table.
>>
GO TO 2.
CHECK INTELLIGENT KEY SYSTEM (REMOTE KEYLESS ENTRY FUNCTION)
Press the LOCK button of Intelligent Key.
Are all doors LOCKED?
YES>>
GO TO 3.
NO>>
Check Intelligent Key system (remote keyles ...
Inspection
INSPECTION AFTER INSTALLATION
INSPECTION AFTER INSTALLATION
The following are procedures for checking fluid leakage, lubricant leakage.
Before starting engine, check oil/fluid levels including engine coolant and engine oil. If any are less than the required quantity, fill them to the specified level ...