Removal and Installation
REMOVAL
Remove radiator air guide upper. Refer to Removal and Installation.
Remove front combination lamp. Refer to Removal and Installation.
Remove active grille shutter upper side mounting bolts. Refer to Removal and Installation.
Remove hood lock assembly. Refer to Removal and Installation.
Disengage fixing clips from radiator core support.
Remove horn low. Refer to Removal & Installation.
Disconnect intelligent key warning buzzer harness connector. Refer to Removal and Installation.
Remove radiator mounting bolts on radiator core support. Refer to RADIATOR : Removal & Installation.
Remove radiator core support mounting bolts, and then remove radiator core support.
Installation
Install in the reverse order of removal.
Other materials
Cleaning exterior
Basic information
Maintaining the exterior of your Nissan Armada is essential not only for preserving
its visual appeal but also for protecting the paintwork and body components over
time.
To keep the Nissan Armada in optimal condition, wash the vehicle promptly under
the following circumsta ...
Tire Pressure Sensor Id Registration
Description
This procedure must be performed.
After replacement of a tire pressure sensor or BCM.
After replacement of tire or road wheel.
NOTE:
ID registration is unnecessary if there are no change in the positions of each wheels (tire pressure sensors) before wheel removal and after wheel inst ...
Second Heated Seat System
Symptom Table
Symptom Possible causeInspection item
Second heated seat system does not operate
Display unit and rear A/C control operation does not operate
Fuse
Second seat heater power supply/ground/LIN signal circuit
Second seat cushion heater
Second seatback heater
A/C auto amp.
Check second ...