Exploded View

![]() |
Tire | ![]() |
Air valve | ![]() |
Wheel |
![]() |
: For non-reusable parts, refer to the TPMS configuration diagram. Refer to TIRE PRESSURE SENSOR : Exploded View. |
||||
: N·m (kg-m, ft-lb) |
|||||
Removal & Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
Remove wheel nuts with power tool (commercial service tool).
Remove tire assembly.
INSTALLATION
Note the following, install in the reverse order of removal.
-
When replacing or rotating wheels, perform the "TIRE PRESSURE SENSOR ID REGISTRATION". Refer to Work Procedure.
Inspection
ALUMINUM WHEEL
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed, remove wheel and check wheel runout.Remove tire from aluminum wheel and mount on a tire balance machine. Set dial indicator as shown in the figure.

or radial runout
exceeds the limit, replace aluminum wheel.
| Limit | |
| Axial runout | Refer to ROAD WHEEL : Service Data. |
| Radial runout | Refer to ROAD WHEEL : Service Data. |
Other materials
Intelligent Around View Monitor system operation
The Nissan Armada Intelligent Around View Monitor utilizes multiple strategically
positioned cameras 1, including units mounted in the front grille, beneath the outside
mirrors, and above the rear license plate, to create a comprehensive multi-angle
view of the vehicle surroundings.
Basic ...
Rear Door
Removal and Installation
REMOVALRemove rear door finisher. Refer to Removal & Installation.
Disconnect outside key antenna (rear door) harness connector.
Disengage outside key antenna (rear door) fixing clips, and then remove outside key antenna (rear door) .
: Clip
Disengage clip fixing ...
Drive Mode Select Switch
Exploded View
Select switch unit
Drive mode select switch
Removal and Installation
Remove select switch unit. Refer to VDC OFF SWITCH : Removal & Installation.
Unhook the pawls () to remove the drive mode select switch from the select switch unit .
INSTALLATIONInstall in ...



: N·m (kg-m, ft-lb)