Nissan Armada 2025-2026 Service and Repair Manual: Side Radar Alignment

Work Procedure

Always perform the side radar configuration after replacing the side radar. SIDE RADAR CONFIGURATION >> GO TO 2. SIDE RADAR ALIGNMENT Perform the side radar alignment with CONSULT. Refer to W ...

Work Procedure

Always perform the side radar alignment after performing the following work. After removing and installing or replacing the side radar. After removing and installing, replacing or repainting the rear ...

Other materials:

Work Procedure
Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the around view monitor control unit. The use of CONSULT is required to perform calibration or writing of calibration results to the ar ...

Condition of the Panel
Before beginning, thoroughly check the panel and make any necessary corrections. (1) CLEARANCE BETWEEN WELDING SURFACES Gaps between the surfaces to be welded cause poor current flow. Even if welding could be done without removing such gaps, the welded area would be smaller, resulting in poor streng ...

PRECAUTIONS FOR REMOVING BATTERY TERMINAL : Precautions
NOTE: NOTE: NOTE: The removal of 12V battery may cause a DTC detection error. HOW TO DISCONNECT 12V BATTERY TERMINAL Disconnect 12V battery terminal according to instruction described below. Open the hood. Turn ignition switch to the ON position. Turn ignition switch to the OFF position with the d ...