Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Sunshade Motor Assembly

Exploded View

Refer to Exploded View.

Removal and Installation

REMOVAL

CAUTION:

  • Before removing sunshade motor, check that sunshade is fully opened.

  • After removing sunshade motor, never attempt to rotate sunshade motor assembly as a single unit.

Remove headlining to make work space. Refer to Removal and Installation.

Disconnect harness connector, and then disengage harness connector assembly fixing clip.

Remove fixing screws , and then remove sunshade motor assembly.

INSTALLATION

CAUTION:

  • Install moonroof motor assembly and sunshade motor assembly in correct position without mistake.

  • Before installing the sunshade motor assembly, always place the link and wire of sunshade slider in the symmetrical and fully opened position.

Move the sunshade motor assembly laterally a little so that the gear is completely engaged into the wire on the moonroof unit assembly and mounting surface becomes parallel. Then secure the sunshade motor assembly with screws.

Install harness connector assembly, and then connect harness connector.

Install headlining. Refer to Removal and Installation.

CAUTION:

After installing sunshade motor assembly, perform additional service. Refer to Description.

    Other materials

    Rear Drive Shaft
    Inspection WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System. Check the following ...

    Back Door Lock
    Exploded View Back door touch sensor*1 Back door lock & closure assembly Back door panel Back door stay lower bracket Spindle unit*1 Spindle unit bracket upper*1 Bracket cover*2 Hands free control unit*2 Hands free sensor bracket*2 Hands free sensor upper*2 Hands free ...

    Repairing Material
    Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially available Urethane foam for sealant (foam materi ...