NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Third Seat Belt Buckle

Nissan Armada 2025-2026 Service and Repair Manual / Restraints / Seat Belt / Third Seat Belt Buckle

Removal and Installation

REMOVAL

Seat Belt Buckle LH and Connector Buckle

Remove luggage floor board LH. Refer to Removal and Installation.

Disconnect harness connector.

Remove seat belt buckle LH and connector buckle mounting anchor bolt .

Pull out seat belt buckle LH and connector buckle from third seat.

Seat Belt Buckle RH and Center Seat Belt Buckle

Remove luggage floor board RH. Refer to Removal and Installation.

Disconnect harness connector.

Remove seat belt buckle RH and center seat belt buckle mounting anchor nut .

Pull out seat belt buckle RH and center seat belt buckle from third seat.

Remove anchor plate lower mounting nuts , and then remove anchor plate lower.

INSTALLATION

Install in the reverse order of removal.

Inspection

AFTER A COLLISION

WARNING:

To avoid the risk of death or severe injury:

  • Inspect all seat belt system components including the seat belt webbing, retractors, pretensioners, buckles, anchors, and attaching hardware after any collision.

  • Inspect all seat belt assemblies and components including webbing, retractors, buckles, anchors and attaching hardware not in use during a collision. Replace if either damage or improper operation is noted.

  • Failure to follow any of the above steps could result in serious personal injury in an accident.

Replace any seat belt assembly (including anchor bolts) if:

  • The seat belt is in use at the time of a collision (except for minor collisions and the belts, retractors and buckles show no damage and continue to operate properly).

  • The seat belt is damaged in an accident (i.e. torn webbing, bent retractor or guide, etc.).

  • The seat belt attaching point is damaged in an accident. Inspect the seat belt attaching area for damage or distortion and repair if necessary before installing a new seat belt assembly.

  • Anchor bolts are deformed or worn out.

  • The seat belt assembly must be replaced even if the seat belts were not in use during the collision in which the air bags were deployed.

PRELIMINARY CHECKS

Check the seat belt warning lamp for proper operation. Refer to Seat Belt Warning Lamp.

If the air bag warning lamp turns ON, perform self-diagnosis using CONSULT. Refer to CONSULT Function.

Check that the seat belt retractor, seat belt anchor and buckle bolts are tightened firmly.

Repeat steps above if necessary to check the other seat belts.

    Other materials

    Precautions
    Precautions for Removing Battery Terminal When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below. NOTE: Some ECUs operate for a certain fixed time even after ignit ...

    Precautions
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger fo ...

    Back Door Side Garnish
    Removal and Installation CAUTION: Never damage the back door panel.REMOVALCAUTION: When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove back door inner finisher. Refer to Removal and Installation. Remove back door upper garnish. Refer to Removal and ...