Removal & Installation
NOTE:
Perform ADDITIONAL SERVICE WHEN REPLACING 8CH CAN GATEWAY. Refer to Description.
REMOVAL
Remove instrument lower panel LH. Refer to Removal and Installation.
Remove front center console body assembly. Refer to Removal and Installation.
Remove center instrument lower panel. Refer to Removal and Installation.
Remove 8CH CAN gateway 
harness connectors 
.
Pull out 8CH CAN gateway from the steering member.
INSTALLATION
Install in the reverse order of removal.
Other materials
Jump starting
To start your Nissan Armada engine using a booster battery, it is essential to
carefully follow the proper procedures and safety precautions outlined below to
avoid damage or injury.
WARNING
Improper jump starting of the Nissan Armada can result in a battery explosion,
causing severe inj ...
Low Tire Pressure Warning Lamp Does Not Turn Off
Description
The low tire pressure warning lamp does not turn OFF after several seconds is passed after engine starts.
Diagnosis Procedure
CHECK TIRE PRESSURE
Ignition switch ON.
CAUTION:
Never start the engine.
Check the tire pressure for all wheels and adjust to the specified value. Refer to TI ...
Rear Fillet Molding Rear
Removal and Installation
REMOVALRemove rear fillet molding rear fixing clips and screws .
Apply protective tape (A) on the part to protect it from damage.
Insert a remover tool (A) between rear fillet molding rear and rear fender panel, and then cut double-sided tape using a cutter (B) while li ...