Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Rear Fillet Molding Rear

Removal and Installation

REMOVAL

Remove rear fillet molding rear fixing clips and screws .

Apply protective tape (A) on the part to protect it from damage.

Insert a remover tool (A) between rear fillet molding rear and rear fender panel, and then cut double-sided tape using a cutter (B) while lifting rear fillet molding rear.

Disengage fixing clips, and then remove rear fillet molding rear indicated by arrows as shown in the figure.

: Clip

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

  • Always replace double-sided tape with a new one, if rear fillet molding rear is reused.

  • Remove double-sided tape remaining on rear fender panel and back of rear fillet molding rear with a double-sided tape remover, after removing rear fillet molding rear.

  • Degrease rear fillet molding rear mounting surface of rear fender panel.

  • Paint grain or dust on mounting surface of rear fillet molding rear may spoil exterior appearance if it remains. Clean the mounting surface and check that no paint grain or dust remains, before starting the operation.

  • When installing rear fillet molding rear, visually check the clips, then replace it with new parts if they are damaged.

  • When installing rear fillet molding rear, check that clips are securely fitted in holes, and then press it in.

  • Never wash the vehicle within 24 hours after installing so as to keep adhesive.

    Other materials

    How to enable/disable the systems
    Vehicle information display Steering-wheel-mounted controls (right side) Basic information In the Nissan Armada, a wide range of Driver Assistance systems can be easily customized through the vehicle information display. Using the steering-wheel-mounted controls, the driver can navi ...

    Rear Oil Seal
    Exploded View Transfer assembly Rear oil seal     : vehicle front : Always replace after every disassembly. : Apply transfer fluid. Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/ ...

    Rear Door Outside Handle
    Removal and Installation REMOVALRemove rear door finisher. Refer to Removal and Installation. Remove rear door inner frame. Refer to Removal and Installation. Disconnect rear door outside handle harness connector , and then disengage rear door outside handle harness connector fixing clip (if equipp ...