Description
Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time the harness connector of the accelerator pedal position sensor or ECM is disconnected. (For details, refer to Work Procedure .)
Work Procedure
START
-
Make sure that accelerator pedal is fully released.
-
Ignition switch ON and wait at least 2 seconds.
-
Ignition switch OFF and wait at least 10 seconds.
-
Ignition switch ON and wait at least 2 seconds.
-
Ignition switch OFF and wait at least 10 seconds.
>>
END
Other materials
Precautions
Precautions for removing battery terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Driver Air Bag Module
Exploded View
Steering wheel
Driver air bag module
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discha ...
12v Sub Battery (lithium Ion Battery)
Exploded View
12V SUB BATTERY (LITHIUM ION BATTERY) HARNESS
12V sub battery (lithium ion battery) harness 1
: To 12V sub battery (lithium ion battery)
: vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
12V SUB BATTERY (LITHIUM ION BATTERY)
:12V ...