Work Procedure
Always perform the rear automatic braking system action test to check that the system operates normally after replacing the ADAS control unit 2 or repairing any rear automatic braking system malfunction.
CHECK REAR AUTOMATIC BRAKING SYSTEM SETTING
-
Start the engine.
-
Check that the rear automatic braking system setting can be enabled/disabled on the combination meter.
>>
INSPECTION END
Other materials
Back Door Finisher Cap
Removal and Installation
CAUTION:
Never damage the back door panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Fully open back door.
Apply protective tape (A) on back door lower finisher to protect it from damage.
Disengage back d ...
Propilot Assist 1.1
Propilot Assist 1.1 System Symptoms
Symptom Table
Symptoms Inspection item/Reference page
Operation
System setting cannot be turned ON/OFF
Refer to Diagnosis Procedure
System cannot be set (ProPILOT Assist switch turns ON/OFF)
Refer to Diagnosis Procedure
CANCEL switch does not func ...
Additional Service When Replacing Adas Control Unit 2
Without Propilot Assist 2.1
Work Procedure
Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
VIN REGISTRATION
Turn ...