CAUTION:
When replacing the BCM, always replace it with a new one. The functions controlled by the BCM does not operate properly in case of reuse of the BCM from another vehicle.
When before pairing of BCM and Intelligent Key unit, always writing the BCM configuration. Or not doing so, BCM control function does not operate normally.
Perform the following operations when replacing BCM. For details, refer to Work Procedure.
AFTER REPLACEMENT
CAUTION:
When after replacing BCM, the following items must be performed. Or not doing so, BCM control function does not operate normally.
Writing vehicle specification
Pairing of BCM and Intelligent Key unit
Register of vehicle identification number
Writing MAC key
Tire pressure sensor ID registration
Remote engine start function activation
Work ProcedureWork Procedure
If system detects that driver is not facing forward even though driver is facing forward, perform face recognition check.
PREPARATION BEFORE FACE RECOGNITION CHECK
Make sure that all of the following conditions are satisfied
Vehicle speed is 0 km/h (stopped).
Shift position is "P" range.
Put driver' ...
Inspection
INSPECTION AFTER REMOVAL
Appearance
Check the following items, and replace the part if necessary.
Lower link for deformation, cracks or damage.
Bushings for complete seperation. (If completely seperated, inner metal can be pulled out from lower link.)
Ball joint boot for cracks or other damage, and ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision.
Information necessary to service the system safely is includ ...