Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the chassis control module. For details the operation, refer to “CONSULT Operation Manual”.
Work Procedure [After Replacing Chassis Control Module]
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to chassis control module according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM NECESSARY WORK
With CONSULT
-
Perform configuration. Refer to Work Procedure.
-
Perform MAC key writing. Refer to Work Procedure.
-
Perform self-diagnosis for “CHASSIS CONTROL”.
-
Erase the memory of self-diagnosis results.
>>
WORK END
Other materials
ProPILOT Assist displays and indicators
ProPILOT Assist and ProPILOT Assist 1.1
ProPILOT activation
Appears once the Nissan Armada ProPILOT Assist system is enabled, confirming
that the driver assistance features are ready to operate and support the driver
during travel.
Steering Assist indicator
Displays the current S ...
Rear Propeller Shaft
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
LOOSENESS OF CONNECT ...
Performance Test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFO-1234yf) or manifold gauge.
Start the engine, and set to the following condition.
Test condition Surrounding condition
Indoors or in the shade
(in a well-ventilated place)
vehicle condition
Door
Closed ...