Work Procedure
DESCRIPTION
When replacing the Combination meter, perform the procedures before and after replacement.
Before Replacement
Take note the odometer mileage of the combination meter. When replacing the combination meter, check that DTC’s are not detected at "self-diagnostic result" of ABS. When detecting DTC’s, perform "self-diagnostic result" of ABS.
After Replacement
After replacing the combination meter, the following items must be performed.
-
Configuration
-
Actual driving 1 km or more
NOTE:
The odometer mileage of the combination meter is also stored and memorized in the ABS actuator and electric unit (control unit). When driving 1 km or more after replacement of the combination meter, the memorized mileage in the ABS actuator and electric unit (control unit) is written into the new combination meter.
WORK PROCEDURE
COMBINATION METER CONFIGURATION
Perform the combination meter configuration with CONSULT. Refer to Work Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of combination meter with CONSULT. Check if any DTC is detected.
Is any DTC detected?
YES>>Perform the trouble diagnosis for the detected DTC. Refer to DTC Index.
NO>>GO TO 3.
DRIVING TEST
Drive the vehicle on the road 1 km or more.
Check that the odometer shows more than the mileage taken note before.
>>INSPECTION END
Other materials
Noise, Vibration and Harshness (nvh) Troubleshooting
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference
DRIVE SHAFT FRONT AXLE
Noise Shake Noise Shake Vibration Shimmy Judder Poor quality ride or handling
Excessive ...
Driving Video Recorder Control Module
Removal and Installation
REMOVALCAUTION:
Before replacing driving video recorder control module, perform “ADDITIONAL SERVICE WHEN REPLACING DRIVING VIDEO RECORDER CONTROL MODULE”. For details, refer to Work Procedure.
Before replacing the driving video recorder control module, the customer s ...
Distance Sensor Alignment
Work Procedure
Always perform the radar alignment after removing and installing or replacing the distance sensor. Application Notice Type Description
TYPE 1
When using KV99112700 for radar alignment. Refer to Description.
TYPE 2
When using 1-20-2851-1 for radar alignment. Refer to Descript ...