NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Power Steering Control Module Control Unit

Nissan Armada 2025-2026 Service and Repair Manual / Steering / Steering Control System / Additional Service When Replacing Power Steering Control Module Control Unit

Work Procedure

DESCRIPTION

When replacing the power steering control module, the procedures of AFTER REPLACEMENT must be performed.

AFTER REPLACEMENT

After replacing the power steering control module, the following items must be performed:

  • Power steering control module programming.

  • Power steering control module configuration.

  • Adjustment of steering angle sensor neutral position.

  • Steering torque calibration.

  • Rack end value reset.

WORK PROCEDURE

REPLACE POWER STEERING CONTROL MODULE

With CONSULT

  1. Select "Replace ECU" of "EPS/DIRECT ADAPTIVE STEERING 3".

  2. Perform writing vehicle specification to power steering control module according to "Replace ECU" in CONSULT Operation Manual.

CAUTION:

During work, maintain the following conditions:

  • Ignition switch: ON

  • Electric load: OFF

  • vehicle speed: 0 km/h (MPH)

  • 12V battery voltage: 10.5 V or more

  • Steering angle : ±90 °or less

  • Steering wheel: Do not touch

NOTE:

Writing of programming and configuration is automatically.

>>

GO TO 2.

PERFORM NECESSARY WORK

  1. Perform adjustment of steering angle sensor neutral position. Refer to Work Procedure.

  2. Perform steering torque calibration. Refer to Work Procedure.

  3. Perform rack reset. Refer to Work Procedure.

  4. Perform self-diagnosis for “EPS/DIRECT ADAPTIVE STEERING 3”.

  5. Erase the memory of self-diagnosis results.

>>

End of work.

    Other materials

    Back Door Side Garnish
    Removal and Installation CAUTION: Never damage the back door panel.REMOVALCAUTION: When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove back door inner finisher. Refer to Removal and Installation. Remove back door upper garnish. Refer to Removal and ...

    Anti-Pinch Inspection
    Description Check anti-pinch function when the initialization of moonroof and sunshade system is performed. Refer to Work Procedure. Work Procedure CHECK ANTI-PINCH FUNCTION Fully open the moonroof. Place a piece of wood near the fully closed position. Close the moonroof completely with auto c ...

    High-Mounted Stop Lamp
    Exploded View High-mounted stop lamp harness Rear spoiler High-mounted stop lamp : Pawl : N·m (kg-m, in-lb) Removal and Installation CAUTION: Disconnect battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to ...