CAUTION:
When replacing the sonar control unit, always replace it with a new one. Sonar system does not operate properly in case of reuse of the sonar control unit from another vehicle.
When before writing the sonar control unit configuration, always writing the MAC key.
Perform the following operations when replacing sonar control unit. For details, refer to Work Procedure.
AFTER REPLACEMENT
When after replacing sonar control unit, the following items must be performed. Or not doing so, sonar system does not operate normally.
Writing vehicle specification
Configuration
Writing MAC key
Work ProcedureInformation Display
DISTANCE TO EMPTY
The calculated distance to empty may differ from the actual distance to empty if the refueling amount is approximately 6 (1 3/8 Imp gal) or less. This is because the refuel control (moves the fuel gauge needle quicker than normal judging that the driver is refueling the vehicle) i ...
Adjustment
Rear moonroof glass Glass lid Roof panel
NOTE:
Standard of surface height is given assuming that the glass upper side status is (+), and the glass lower side status is (−) relative to the roof panel.
Unit: mm [in]
Portion Standard Roof panel – Rear moonroof glass – E Clearance 6.4 †...
Removal and Installation
REMOVAL
Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.
Set suitable jack under rear lower link.
CAUTION:
Check the stable condition when using a suitable jack.
Never damage rear lower link.
Loosen rear lower link mounting nuts (frame side).
Separate rear lower link from axl ...