Description
When replacing transfer control unit, the following work is required. For the work procedure, refer to Work Procedure.
WORK AFTER REPLACEMENT
-
Unit parameter writing
-
Initial calibration
Work Procedure
WRITING THE REQUIRED INFORMATION FOR CONTROL UNIT REPLACEMENT
With CONSULT
-
Ignition switch ON.
-
Select "AWD/4WD".
-
Select "Replace ECU".
-
Perform the work according to the procedure displayed in CONSULT.
CAUTION:
The following conditions must be maintained during ECU modernization procedure.
-
Ignition switch ON.
-
All electric loads are OFF
-
Brake pedal is not depressed.
-
Battery voltage: 12-13.5 V (Be sure to check the value of battery voltage by CONSULT.)
NOTE:
Writing of control unit information is performed automatically.
-
>>
GO TO 2.
WRITING UNIT PARAMETER
Perform writing of the unit parameter to transfer control unit. Refer to Work Procedure.
>>
GO TO 3.
INITIAL CALIBRATION
-
Continue the following condition.
Transmission position : P
4WD mode : AUTO
-
Depress the brake pedal.
-
Start the engine and wait for approximately 10 seconds under the brake pedal depressed.
>>
GO TO 4.
PERFORM SELF-DIAGNOSIS
With CONSULT
-
Erase self-diagnostic results for “AWD/4WD”.
-
Ignition switch ON to OFF.
CAUTION:
Wait for 60 seconds after ignition switch OFF.
-
Depress the brake pedal.
-
Start the engine.
CAUTION:
Never drive the vehicle.
-
Perform self-diagnosis for “AWD/4WD”.
Is any DTCs detected?
YES>>Check DTC detected item. Refer to DTC Index.
NO>>WORK END
Other materials
Precautions on supplemental restraint system
This section describes the Supplemental Restraint System (SRS) in the Nissan
Armada and provides essential safety information regarding its operation. The Nissan
Armada is equipped with multiple advanced protection systems designed to work together
with seat belts to reduce the risk of injury ...
Disc Rotor
Inspection
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
INSPECTIONUneven wea ...
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...