NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Additional Service When Replacing Transmission Assembly

Nissan Armada 2025-2026 Service and Repair Manual / Transmission & Driveline / Transaxle & Transmission. 9at: Ge9r01a / Additional Service When Replacing Transmission Assembly

Description

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

When replacing the transmission assembly, perform the following work. For work procedure, refer to Work Procedure.

WORK AFTER TRANSMISSION ASSEMBLY REPLACEMENT

  • Vehicle specifications writing

    CAUTION:

    Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT.

  • Calibration of decel G sensor

Work Procedure

WARNING:

  • Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.

REPLACE A/T ASSEMBLY

Replace A/T assembly. Refer to Removal and Installation (2WD) or Removal and Installation (4WD).

>>

GO TO 2.

WRITING vehicle SPECIFICATIONS

With CONSULT

  1. Ignition switch ON.

  2. Select "TRANSMISSION".

  3. Select "Replace ECU".

  4. Perform the work according to the procedure displayed in CONSULT.

CAUTION:

If the shift position is not displayed on the combination meter after writing the vehicle specifications, confirm that the shift position is displayed on the combination meter after performing one of the following actions.

  • Turn the ignition switch OFF and wait until the combination meter turns off. Then turn the ignition switch ON.

  • Disconnect the 12V battery terminal and reconnect it. Then turn the ignition switch ON. Refer to Precautions for Removing Battery Terminal.

>>

GO TO 3.

CALIBRATE DECEL G SENSOR

  1. Perform decel G sensor calibration. Refer to Description.

  2. Clear any DTCs that may have set and then test drive the vehicle.

>>

WORK END

    Other materials

    Diagnosis and Repair Work Flow
    Work Flow (Heated Steering Wheel) DETAILED FLOWOBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred) as much as possible when the customer brings the vehicle in. >> GO TO 2. REPRODUCE THE MALFU ...

    Steering Wheel Turning Force Is Heavy or Light
    Description Steering wheel turning force is heavy or light. Diagnosis Procedure PERFORM SELF-DIAGNOSIS With CONSULT Pull the parking brake switch. NOTE: Check to make sure that the parking brake switch indicator is turned ON. Ignition switch OFF. Get out of the vehicle and close all doors. W ...

    Condenser Inlet Pipe
    Removal and Installation REMOVALCAUTION: Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation. When disconnec ...