Removal and Installation
CAUTION:
Never damage the body panel.
REMOVAL
CAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.
Remove center pillar lower garnish. Refer to Removal and Installation.
Pull out tongue of seat belt pre-tensioner retractor from buckle of lap pre-tensioner. Refer to Removal and Installation.
Apply protective tape (A) on center pillar upper garnish to protect it from damage.
Disengage pillar cap fixing pawls of center pillar upper garnish using a remover tool (A), and then remove pillar cap of center pillar upper garnish.
 |
: Pawl |
Remove center pillar upper garnish mounting bolt.
Disengage center pillar upper garnish lower side fixing clip.
 |
: Clip |
Pull out seat belt, and then remove center pillar upper garnish.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Visually check clip for deformation and damage during installation. Replace with new ones if necessary.
-
Check in advance that clip is accurately aligned with the hole on body panel, and then install by pressing in.
-
After installation, check that the lip of body side welt covers. Refer to Inspection.
Other materials
RearView Monitor system limitations
WARNING
The Nissan Armada RearView Monitor has certain operational limitations that
must always be taken into account. Ignoring these limitations or relying solely
on the system without proper visual checks may result in serious injury or even
fatal accidents.
The Nissan Armada camera sys ...
Front Automatic Air Conditioning System
Symptom Table
NOTE:
Perform self-diagnoses with CONSULT before performing the symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis. Symptom Corresponding malfunction part Check item/Reference
Front air conditioning system does not activate.
NOTE:
Fail-safe does not acti ...
Front Wiper Arm
Removal and Installation
CAUTION:
Clean windshield glass and front wiper refill so that windshield glass may not be damaged by dust, etc. REMOVALOperate front wiper to the auto stop position. Refer to System Description.
Fully open hood assembly.
Remove front wiper arm cap.
Remove front wiper arm ...