Nissan Armada 2025-2026 Service and Repair Manual: Commercial Service Tool
| Tool name | Description | |
|---|---|---|
| Drive shaft puller |
| Removing drive shaft joint sub assembly |
| Sliding hammer |
| Removing drive shaft |
| Power tool |
| Loosening bolts and nuts |
| Ball joint remover |
|
|
Special Service Tool
Tool number
(TechMate No.)
Tool name Description KV40104001
(NI-53385)
Hub lock nut wrench
a: 85 mm (3.35 in)
b: 65 mm (2.56 in)
Removing and Installing wheel hub lock nut. KV40107300
(NI-51751)
B ...
Lubricant or/and Sealant
Name Description NISSAN Genuine grease or equivalent Joint sub-assembly inside
Housing inside
Apply paste [service parts (440037S000)] Joint sub-assembly
...
Other materials:
Work Procedure
Always perform the side radar alignment after performing the following work.
After removing and installing or replacing the side radar.
After removing and installing, replacing or repainting the rear bumper.
Side radar alignment conditions are following;
The vehicle speed is 20 km/h (13 MPH) or hig ...
Removal and Installation
REMOVAL
Remove rear bumper energy absorber. Refer to Removal and Installation.
Remove harness clip .
Disconnect outside key antenna (rear bumper) harness connector.
Remove outside key antenna (rear bumper) fixing nuts , and then remove outside key antenna (rear bumper) .
INSTALLATION
Install in th ...
Diagnostic Work Sheet
Description
INTERVIEW SHEET SAMPLE
Interview sheet Customer name MR/MS Registration number Initial year registration Vehicle type VIN Storage date Engine Mileage km/Mile Symptom □ Does not operate ( ) function □ Warning lamp for ( ) turns ON □ Noise           ...
0.0074