Nissan Armada 2025-2026 Service and Repair Manual: Configuration
Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit).
The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle specification to the ABS actuator and electric unit (control unit).
Refer to Work Procedure.
NOTE:
For details the network connection and operation, refer to “CONSULT Operation Manual”.
The configuration no need to “save” configuration data from the ABS actuator and electric unit (control unit). The configuration data is always generated freshly at the server and then downloaded to the CONSULT.
CAUTION:
Complete the procedure of “Configuration” in order.
If incorrect “Configuration”, incidents might occur.
Never perform “Configuration” except for new ABS actuator and electric unit (control unit).
Work Procedure
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the ABS actuator and electric unit (control unit). For details the operation, refer to “C ...
Work Procedure
WRITING VEHICLE SPECIFICATION
With CONSULT
Perform writing vehicle specification to ABS actuator and electric unit (control unit) following "Automatic Configuration" procedure of "Configuration" accor ...
Other materials:
Work Procedure
REPLACE DRIVER SEAT CONTROL UNIT
Replace driver seat control unit. Refer to Removal and Installation.
>>
GO TO 2.
Vehicle SPECIFICATION RECOGNITION
Connect battery negative terminal. Power switch ON and wait for 30 seconds or more.
NOTE:
When the driver seat control unit receives a signal f ...
Inspection
WARNING:
DESCRIPTION
Measure wheel alignment under unladen conditions.
NOTE:
“Unladen conditions” means that fuel, engine coolant, and lubricant are full. Spare tire, jack, hand tools and mats are in designated positions.
PRELIMINARY CHECK
Check the following:
Tires for improper air pressure an ...
Precautions for removing battery terminal
NOTE:
NOTE:
NOTE:
The removal of 12V battery may cause a DTC detection error.
HOW TO DISCONNECT 12V BATTERY TERMINAL
Disconnect 12V battery terminal according to instruction described below.
Open the hood.
Turn ignition switch to the ON position.
Turn ignition switch to the OFF position with the d ...
0.0067