Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
REPLACE DRIVER SEAT CONTROL UNIT
Replace driver seat control unit. Refer to Removal and Installation.
>>GO TO 2.
Vehicle SPECIFICATION RECOGNITION
Connect battery negative terminal. Power switch ON and wait for 30 seconds or more.
NOTE:
When the driver seat control unit receives a signal from the AV control unit for 30 seconds after the battery is energized, it is recognized and set as the specifications of with navigation system.
>>GO TO 3.
LOG-IN STORING
Perform log-in storing. Refer to System Description.
>>GO TO 4.
MEMORY STORING
Perform memory storing. Refer to Description.
>>WORK END
Additional Service When Replacing Driver Seat Control Unit
Each function is reset to the following condition when the driver seat control unit is replaced. For details, refer to Work Procedure.
Function Condition Procedure Memory (Seat, steering column, d ...
Additional Service When Replacing Steering Column Control Module
Each function is reset to the following condition when the steering column control module is replaced. For details, refer to Work Procedure.
Function Condition Procedure Memory (Steering column) ...
Other materials:
Work Flow
DETAILED FLOW
INTERVIEW FROM THE CUSTOMER
CAUTION:
>>
GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, based on the information from the customer obtained by the interview. Also check that the symptom is not caused by fail-safe mode. Refer to Fail-safe.
CAUTIO ...
Disassembly and Assembly
DISASSEMBLY
Remove the carrier cover bolts.
Remove carrier cover to insert the seal cutter (A) [SST: KV10111100 (NI-37228)] between gear carrier and carrier cover.
CAUTION:
Never damage the mating surface.
Never insert flat-bladed screwdriver, this will damage the mating surface.
Remove side oil ...
Removal and Installation
WARNING:
REMOVAL
Drain transfer fluid. Refer to Draining.
Remove transfer assembly from vehicle. Refer to Removal and Installation.
Remove the rear companion flange and remove the o-ring.
Remove the rear case mounting bolts .
* : Tighten together with the bracket.
Remove the rear case .
...
0.0089