Work Flow
OVERALL SEQUENCE

DETAILED FLOW
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.
NOTE:
The customers are not professionals. Never assume that “maybe the customer means···” or “maybe the customer mentioned this symptom”.
>>
GO TO 2.
SELF-DIAGNOSIS WITH CONSULT
-
Perform “All DTC Reading” with CONSULT.
-
Check if the DTC is detected on the self-diagnosis results of following.
-
“ICC/ADAS 2”
-
“LASER/RADAR”
-
“LANE CAMERA”
-
Is any DTC detected?
YES>>Record or print self-diagnosis results and freeze frame data (FFD).GO TO 5.
NO>>GO TO 3.
ACTION TEST
Perform Following system action test to check the operation status. Refer to Work Procedure.
Check if any other malfunctions occur.
>>
GO TO 4.
SYMPTOM DIAGNOSIS
Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.
>>
GO TO 6.
TROUBLE DIAGNOSIS BY DTC
-
Erase self-diagnostic results.
-
Ignition switch OFF → ON.
CAUTION:
Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
-
Check the DTC in the self-diagnosis results.
-
Perform trouble diagnosis for the detected DTC following.
-
“ICC/ADAS 2”(Without ProPILOT Assist 2.1): Refer to DTC Index.
-
“ICC/ADAS 2”(With ProPILOT Assist 2.1): Refer to DTC Index.
-
“LASER/RADAR”: Refer to DTC Index
-
“LANE CAMERA”: Refer to DTC Index.
-
NOTE:
If Network-DTC is detected, first diagnose the CAN communication system.
>>
GO TO 6.
MALFUNCTIONING PART REPAIR
Repair or replace the identified malfunctioning parts.
>>
GO TO 7.
REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)
-
Erases self-diagnosis results.
-
Perform “All DTC Reading” again after repairing or replacing the specific items.
-
Check if any DTC is detected in self-diagnosis results of following.
-
“ICC/ADAS 2”
-
“LASER/RADAR”
-
“LANE CAMERA”
-
Is any DTC detected?
YES>>GO TO 5.
NO>>GO TO 8.
REPAIR CHECK (ACTION TEST)
Perform the action test. Check that the malfunction symptom is solved or no other symptoms occur. Refer to Work Procedure.
Is there a malfunction symptom?
YES>>GO TO 4.
NO>>INSPECTION END
Other materials
Precautions
Precautions for Removing Battery Terminal
When disconnecting the 12V battery terminal, turn off the ACC power before disconnecting the 12V battery terminal, observing “How to disconnect 12V battery terminal” described below.
NOTE:
Some ECUs operate for a certain fixed time even after ignit ...
Third Seat Belt
Exploded View
Anchor bolt
Seat belt pre-tensioner retractor RH
Seat belt pre-tensioner retractor LH
Retaining washer
Spacer
Shoulder anchor LH
Shoulder anchor RH
Bush
Seat belt finisher LH
Seat belt finisher RH
Anchor plate LH
Anchor plate RH
Anchor nut
S ...
Front Door Pocket Lamp
Exploded View
Front door pocket lamp is integrated structure with front door finisher. For exploded view of front door finisher, refer to Exploded View.
Replacement
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric ...