NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Diagnosis and Repair Work Flow

Nissan Armada 2025-2026 Service and Repair Manual / Cruise Control & Driver Assistance / Driver Assistance System. Driver Assistance System / Diagnosis and Repair Work Flow

Work Flow

Without ProPILOT Assist 2.1

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW FOR MALFUNCTION

It is important to clarify the customer’s concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE:

The customers are not professionals. Never assume that “maybe the customer means...” or “maybe the customer mentioned this symptom”.

>>

GO TO 2.

SELF-DIAGNOSIS WITH CONSULT

CONSULT

  1. Perform “All DTC Reading” mode.

  2. Check if the DTC is detected in the “Self Diagnostic Result” of the following:

    • “ICC/ADAS 2”

    • “LASER/RADAR”

    • “LANE CAMERA”

    • “Side radar (Rear left)”

    • “Side radar (Rear right)”

Is any DTC detected?

YES>>

Record or print self-diagnosis results and freeze frame data (FFD).GO TO 5.

NO>>

GO TO 3.

ACTION TEST

  1. Perform the system action test to check the operation status of the following:

    • LDW: Refer to Work Procedure.

    • I-LI: Refer to Work Procedure.

    • BSW: Refer to Work Procedure.

    • I-BSI: Refer to Work Procedure.

    • TSR: Refer to Work Procedure.

    • RCTA: Refer to Work Procedure.

    • I-DA: Refer to Work Procedure.

>>

GO TO 4.

SYMPTOM DIAGNOSIS

Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.

>>

GO TO 6.

TROUBLE DIAGNOSIS BY DTC

CONSULT

  1. Erase self-diagnostic results.

  2. Ignition switch OFF → ON.

    CAUTION:

    Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

  3. Check the DTC in the “Self Diagnostic Result”.

  4. Perform trouble diagnosis for the following detected DTC:

    • “ICC/ADAS 2”: Refer to DTC Index.

    • “LASER/RADAR”: Refer to DTC Index.

    • “LANE CAMERA”: Refer to DTC Index.

    • “Side radar (Rear left)”: Refer to DTC Index.

    • “Side radar (Rear right)”: Refer to DTC Index.

NOTE:

If Network-DTC is detected, first diagnose the CAN communication system.

>>

GO TO 6.

MALFUNCTIONING PART REPAIR

Repair or replace the identified malfunctioning parts.

>>

GO TO 7.

REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)

  1. Erase “Self Diagnostic Result”.

  2. Perform “All DTC Reading” mode after repairing or replacing the specific items.

  3. Check if any DTC is detected in self-diagnosis results of the following:

    • “ICC/ADAS 2”

    • “LASER/RADAR”

    • “LANE CAMERA”

    • “Side radar (Rear left)”

    • “Side radar (Rear right)”

Is any DTC detected?

YES>>

GO TO 5.

NO>>

GO TO 8.

REPAIR CHECK (ACTION TEST)

Perform the following system action test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES>>

GO TO 4.

NO>>

Inspection End.

With ProPILOT Assist 2.1

OVERALL SEQUENCE

DETAILED FLOW

INTERVIEW FOR MALFUNCTION

It is important to clarify the customer’s concerns before starting the inspection. Interview the customer about the concerns carefully and understand the symptoms fully.

NOTE:

The customers are not professionals. Never assume that “maybe the customer means...” or “maybe the customer mentioned this symptom”.

>>

GO TO 2.

SELF-DIAGNOSIS WITH CONSULT

CONSULT

  1. Perform “All DTC Reading” mode.

  2. Check if the DTC is detected in the “Self Diagnostic Result” of the following:

    • “ICC/ADAS 2”

    • “LASER/RADAR”

    • “LANE CAMERA”

    • “Side radar (Rear left)”

    • “Side radar (Rear right)”

    • “Side radar (Front left)”

    • “Side radar (Front right)”

    • "HD MAP"

    • "Driver Monitor Camera"

Is any DTC detected?

YES>>

Record or print self-diagnosis results and freeze frame data (FFD).GO TO 5.

NO>>

GO TO 3.

ACTION TEST

  1. Perform the system action test to check the operation status of the following:

    • LDW: Refer to Work Procedure.

    • I-LI: Refer to Work Procedure.

    • BSW: Refer to Work Procedure.

    • I-BSI: Refer to Work Procedure.

    • TSR: Refer to Work Procedure.

    • RCTA: Refer to Work Procedure.

    • I-DA: Refer to Work Procedure.

  2. Check if any other malfunctions occur.

>>

GO TO 4.

SYMPTOM DIAGNOSIS

Perform the applicable diagnosis according to the diagnosis chart by symptom. Refer to Symptom Table.

>>

GO TO 6.

TROUBLE DIAGNOSIS BY DTC

CONSULT

  1. Erase self-diagnostic results.

  2. Ignition switch OFF → ON.

    CAUTION:

    Be sure to wait of 10 seconds after turning ignition switch OFF or ON.

  3. Check the DTC in the “Self Diagnostic Result”.

  4. Perform trouble diagnosis for the following detected DTC:

    • “ICC/ADAS 2”: Refer to DTC Index.

    • “LASER/RADAR”: Refer to DTC Index.

    • “LANE CAMERA”: Refer to DTC Index.

    • “Side radar (Rear left)”: Refer to DTC Index.

    • “Side radar (Rear right)”: Refer to DTC Index.

    • “Side radar (Front left)”: Refer to DTC Index.

    • “Side radar (Front right)”: Refer to DTC Index.

    • "HD MAP": Refer to DTC Index.

    • "Driver Monitor Camera": Refer to DTC Index.

NOTE:

If Network-DTC is detected, first diagnose the CAN communication system.

>>

GO TO 6.

MALFUNCTIONING PART REPAIR

Repair or replace the identified malfunctioning parts.

>>

GO TO 7.

REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT)

  1. Erase “Self Diagnostic Result”.

  2. Perform “All DTC Reading” mode after repairing or replacing the specific items.

  3. Check if any DTC is detected in self-diagnosis results of the following:

    • “ICC/ADAS 2”

    • “LASER/RADAR”

    • “LANE CAMERA”

    • “Side radar (Rear left)”

    • “Side radar (Rear right)”

    • “Side radar (Front left)”

    • “Side radar (Front right)”

    • "HD MAP"

    • "Driver Monitor Camera"

Is any DTC detected?

YES>>

GO TO 5.

NO>>

GO TO 8.

REPAIR CHECK (ACTION TEST)

Perform the following system action test. Check that the malfunction symptom is solved or no other symptoms occur.

Is there a malfunction symptom?

YES>>

GO TO 4.

NO>>

Inspection End.

    Other materials

    Rear Oil Seal
    Exploded View Transfer assembly Rear oil seal     : vehicle front : Always replace after every disassembly. : Apply transfer fluid. Removal and Installation WARNING: Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/ ...

    Massage Switch
    Removal and Installation REMOVALRemove outside seat cushion finisher outer. Refer to Disassembly and Assembly. Disengage massage switch harness fixing clip. : Clip Remove fixing screws and then remove massage switch. INSTALLATIONInstall in the reverse order of removal. ...

    When Both Power Window Main Switch and Front Power Window Switch Are Operated
    Diagnosis Procedure CHECK FRONT POWER WINDOW MOTOR (PASSENGER SIDE) POWER SUPPLY AND GROUND CIRCUIT Check front power window motor (passenger side) power supply and ground circuit. Refer to Diagnosis Procedure. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace t ...