Work Procedure
-
Always perform the distance sensor configuration after replacing the distance sensor.
-
Always perform the radar alignment after removing and installing or replacing the distance sensor.
CAUTION:
The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.
-
Perform the AEB system action test to check that the AEB system operates normally.
DISTANCE SENSOR CONFIGURATION
Perform saving vehicle internal information according to "Replace ECU" in CONSULT Operation Manual.
>>
GO TO 2.
PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to Work Procedure.
>>
GO TO 3.
AEB SYSTEM ACTION TEST
-
Perform the following system action test.
-
LDW: Refer to Work Procedure.
-
I-LI: Refer to Work Procedure.
-
BSW: Refer to Work Procedure.
-
I-BSI: Refer to Work Procedure.
-
TSR: Refer to Work Procedure.
-
RCTA: Refer to Work Procedure.
-
I-DA: Refer to Work Procedure.
-
-
Check that the each system operates normally.
>>
INSPECTION END
Other materials
Intelligent Key operating range
The Nissan Armada Intelligent Key system functions only when the key is located
within the defined operating range of the request switches 1 and 2 (if equipped).
For optimal performance, the Nissan Armada Intelligent Key must be within approximately
80 cm (31.50 in) of each request switch.
...
Lifting Point
Pantograph Jack
WARNING:
Jacking up or lifting up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System (With electronic ...
Vin Registration
Description
VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.NOTE:
Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M). (For details, refer to Work Procedure .)
Work Procedure
CHECK VIN
Check the VIN ...