CHECK “AUTO DOOR UNLOCK” SETTING IN COMBINATION METER
Check “Auto Door Unlock” setting is “Ignition OFF”.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Set “IGN OFF” in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES>>INSPECTION END
NO>>Check intermittent incident. Refer to Intermittent Incident.
Removal and Installation
REMOVAL
Remove automatic back door switch finisher. Refer to Removal and Installation.
Disengage automatic back door close switch assembly fixing pawls using a remover tool (A), and then remove automatic back door close switch assembly from automatic back door switch finisher.
: Pawl
INSTALLAT ...
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
PERFORM SELF-DIAGNOSIS RESULT
Select “Self Diagnostic Result” mode of “INTELLIGENT KEY”, and check if DTC is detected.
Is DTC detected?
YES>>
Perfor ...
General Specification
Applied model Axle 2WD Engine VR35DDTT Transmission A/T Rear final drive R240 without differential lock Propeller shaft model 3F C-C-C Number of joints 3 Joint type 1st joint Universal (Solid type) 2nd joint Universal (Solid Type) 3rd joint Universal (Solid Type) Coupling method ...