Exploded View
 |
Steering member |  |
Driver knee air bag module | ||
 |
: Always replace after every disassembly. | ||||
 |
: N·m (kg-m, in-lb) | ||||
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
-
Before servicing, ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). Refer to Precautions for Removing Battery Terminal.
-
Always work from the side of air bag module. Never work in front of it.
-
Never use air tools or electric tools for servicing.
REMOVAL
Remove instrument lower panel LH. Refer to Removal and Installation.
Remove driver knee air bag module mounting bolts 
.
Move driver knee air bag module from steering member, and then disconnect driver knee air bag module harness connector .
CAUTION:
-
Never damage harness connector.
-
Insert remover tool (A) wrapped in tape between connector and lever
, and then disconnect harness connector while moving the lever.
Remove driver knee air bag module.
CAUTION:
-
To prevent accidental explosion, always place the driver knee air bag module with deploying direction facing upward.
: Upward -
To prevent damage to the parts, never impact the driver knee air bag module.
-
Replace driver knee air bag module if it is dropped or sustains an impact.
-
To prevent accidental explosion, never insert any foreign objects (screwdriver, etc.) into the driver knee air bag module.
-
To prevent accidental explosion, never disassemble the driver knee air bag module.
-
To prevent accidental explosion, never expose the driver knee air bag module to temperature of more than 90 °C (194 °F).
-
To prevent damage to the parts, never allow oil, grease, detergent, or water to come in contact with the driver knee air bag module.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Never reuse mounting bolts after removal, replace with new bolts.
-
Never damage the harness while installing.
-
When connect driver knee air bag harness connector, press harness connector until clicking sound.
-
After installing the connector, check that the lock is pushed securely into it.
-
After installation is completed, perform self-diagnosis using CONSULT and confirm if the system is normal. Refer to Work Flow.
-
After the work is completed, check that no system malfunction is detected by air bag warning lamp.
Other materials
Rear-facing child restraint installation using LATCH
Before installing a child restraint in the Nissan Armada, carefully review all
warnings and precautions provided in the "Child safety" and "Child restraints" sections
of this manual.
Do not use the LATCH lower anchors if the combined weight of the child and the
child restr ...
Owner's manual/service manual order information
Authentic NISSAN Service Manuals for your Nissan Armada, including this model
year and earlier versions, are available for purchase and provide the most accurate
and comprehensive source of service and repair information.
These official manuals are identical to those used by factory-trained tec ...
Front Door Weather-Strip
Removal and Installation
REMOVALApply protective tape (A) to front door panel around front door weather-strip fixing clips for preventing damage.
Disengage fixing clips on the reverse side of front door weather-strip using a remover tool (A).
: Clip
CAUTION:
Never damage front door pane ...