Exploded View
 |
Instrument panel assembly |  |
Steering member |  |
Passenger air bag module |
 |
: Clip | ||||
 |
: Always replace after every disassembly. | ||||
 |
: N·m (kg-m, ft-lb) | ||||
 : Indicates that the part is connected at points with same symbol in actual vehicle. |
|||||
Removal and Installation
WARNING:
Always observe the following items for preventing accidental activation.
-
Before servicing, ignition switch OFF, disconnect 12V battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit). Refer to Precautions for Removing Battery Terminal.
-
Always work from the side of air bag module. Never work in front of it.
-
Never use air tools or electric tools for servicing.
REMOVAL
Remove instrument panel assembly from steering member. Refer to Removal and Installation.
Disengage passenger air bag module harness connectors fixing clips 
and 
.
Remove passenger air bag module fixing screws .
Remove passenger air bag module.Move passenger air bag according arrow direction as shown in figure, and then disengage fixing hooks .
CAUTION:
-
To prevent accidental explosion, always place the passenger air bag module with deploying direction facing upward.
: Upward -
To prevent damage to the parts, never impact the passenger air bag module.
-
Replace passenger air bag module if it is dropped or sustains an impact.
-
To prevent accidental explosion, never insert any foreign objects (screwdriver, etc.) into the passenger air bag module.
-
To prevent accidental explosion, never disassemble the passenger air bag module.
-
To prevent accidental explosion, never expose the passenger air bag module to temperature of more than 90 °C (194 °F).
-
To prevent damage to the parts, never allow oil, grease, detergent, or water to come in contact with the passenger air bag module.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Never reuse mounting bolts after removal, replace with new bolts.
-
Never damage the harness while installing.
-
After installation is completed, perform self-diagnosis using CONSULT and confirm if the system is normal. Refer to Work Flow.
-
After the work is completed, check that no system malfunction is detected by air bag warning lamp.
Other materials
How to enable/disable the I-DA system
Vehicle information display
Steering-wheel-mounted control (right side)
To enable or disable the Intelligent Driver Alertness system in the Nissan Armada,
follow these steps:
1. Press the
button until "Settings" appears in the vehicle information display, then confirm
...
Brake fluid
Basic information
For detailed specifications regarding brake fluid for your Nissan Armada, refer
to the section "Capacities and recommended fluids/lubricants" in the official documentation.
Maintaining the correct brake fluid condition in the Nissan Armada is essential
for ensuring ...
Transfer Control Unit
Exploded View
Transfer control unit
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking an ...