Removal and Installation
REMOVAL
CAUTION:
Never damage front door glass and front door panel.
Remove front door pull handle bracket. Refer to Removal and Installation.
Remove front door sash inner cover. Refer to Removal and Installation.
Remove hole seals 
from front door panel.
Reconnect power window main switch connector with front door finisher.
NOTE:
The front door finisher is big and heavy component. When reconnect it, use the chair/similar something (A) to support front door finisher as shown in the figure.
Operate power window main switch to raise or lower front door glass until front door glass fixing pawl positions can be seen.
Disengage front door glass fixing pawls of front door module assembly 
using a removal tool (B) according to numerical order 1→2 indicated by arrows as shown in the figure.
 |
: Pawl |
| : vehicle front |
Pull up front door glass to upward, and then remove front door glass.
CAUTION:
Never damage front door glass, front door glass run, and front door panel.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
Never reuse hole seal. Always replace it with a new one when it is removed.
-
After installing front door glass, perform the inspection and adjustment. Refer to Inspection and Adjustment.
Inspection and Adjustment
SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing front door glass. Refer to Work Procedure.
FITTING INSPECTION
-
Check that glass is fitted securely into the sash groove.
-
Lower glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each fastener to correct the glass position if the clearance between the glass and sash are not parallel.
Other materials
When Rear Power Window Switch Lh Is Operated
Diagnosis Procedure
CHECK REAR POWER WINDOW SWITCH LH GROUND CIRCUIT
Check rear power window switch LH ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK REAR POWER WINDOW SWITCH LH
Che ...
Diagnosis and Repair Work Flow
Work Flow
DETAILED FLOWINTERVIEW FROM THE CUSTOMER
CAUTION:
Customers are not professional. Never guess easily like “maybe the customer means that...,” or “ maybe the customer mentions this symptom”.
>>
GO TO 2.
CHECK SYMPTOM
Reproduce the symptom that is indicated by the customer, ...
Additional Service When Replacing Driving Video Recorder Control Module
Work Procedure
DRIVING VIDEO RECORDER CONTROL MODULE REPLACEMENT
Replace driving video recorder control module. Refer to Removal and Installation.
>>
GO TO 2.
WRITING OF VIN DATA TO DRIVING VIDEO RECORDER CONTROL MODULE
With CONSULT
Ignition switch ON and wait at least 5 seconds.
Select ...