Removal and Installation
REMOVAL
CAUTION:
Never damage front door glass and front door panel.
Fully close front door glass.
Remove front door finisher. Refer to Removal and Installation.
Remove front door woofer. Refer to Removal & Installation.
Remove front door glass run from front door lower sash.
Remove front door lower sash mounting bolt 
.
Remove front door lower sash from the hole of front door panel.
CAUTION:
When removing front door lower sash, disengage fixing portion by arrow direction as shown in the figure.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
When installing, insert portion
of front door lower sash 
to hole 
of front door sash (front door panel 
) as shown in the figure.
-
Tighten front door lower sash mounting bolt to the specified torque. Refer to Exploded View.
-
After installing, check the front door glass can be move smoothly. If it could not move smoothly, check the front door glass run has installed to front door lower sash correctly.
Other materials
Rear in-Vehicle Sensor
Removal and Installation
REMOVALRemove rear A/C unit assembly. Refer to Removal and Installation.
Remove rear in-vehicle sensor harness connector from rear A/C unit case LH.
Remove fixing screw , and then remove rear in-vehicle sensor.
INSTALLATIONInstall in the reverse order of removal. ...
Rear Door Outside Handle
Removal and Installation
REMOVALRemove rear door finisher. Refer to Removal and Installation.
Remove rear door inner frame. Refer to Removal and Installation.
Disconnect rear door outside handle harness connector , and then disengage rear door outside handle harness connector fixing clip (if equipp ...
Engine Coolant
Inspection
LEVEL
Check if the reservoir tank engine coolant level is within the “MIN” to “MAX” when the engine is cool.
: MAX
: MIN
Adjust the engine coolant level if necessary.
WARNING:
Never remove reservoir tank cap when engine is hot.
CAUTION:
Refill Genuine NISSAN Long Lif ...