NIARMADA Nissan Armada manuals & owner information
Nissan Armada owner resource

Manuals, service information and practical owner guidance.

Fast access to Nissan Armada manuals, operating instructions, maintenance references and technical information.

Browse manuals →
Nissan Armada manual library

Nissan Armada 2025-2026 Service and Repair Manual: Front Door Module Assembly

Nissan Armada 2025-2026 Service and Repair Manual / Body Exterior, Doors, Roof & Vehicle Security / Glass & Window System / Front Door Glass / Front Door Module Assembly

Removal and Installation

REMOVAL

CAUTION:

Before removing, take a short memo/photo to remember door harness and cable layout.

Remove front door glass. Refer to Removal and Installation.

Disconnect harness connectors , and then disengage harnesses fixing clips.

: Clip

Remove hole seals from front door panel, and then remove front door module assembly mounting bolts from service holes.

Remove front door regulator fasteners.Turn front door regulator fastener counterclockwise to disengage fixing pawls.

: Pawl

Remove front door regulator fastener from front door module assembly.

Disengage fixing pawls, and then remove front door module assembly according to numerical order 1→2 indicated by arrows as shown in the figure.

: Pawl

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:

  • When front door regulator fastener installation, align arrow mark of front door regulator fastener with position mark of front door module assembly .

    Front door panel        

  • Never reuse hole seal. Always replace it with a new one when it is removed.

  • After installing, perform the inspection and adjustment. Refer to Inspection and Adjustment.

Disassembly and Assembly

DISASSEMBLY

Remove front door module assembly. Refer to Removal and Installation.

Remove front door power window motor mounting bolts, and then remove front door power window motor.

ASSEMBLY

Note the following item, and then assemble in the reverse order of disassembly.

CAUTION:

After assembly, perform the inspection and adjustment. Refer to Inspection and Adjustment.

Inspection and Adjustment

SYSTEM INITIALIZATION

Perform additional service for operating the power window control system normally after installing front door regulator. Refer to Work Procedure.

FITTING INSPECTION

  • Check that the glass is fitted securely into the sash groove.

  • Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each mounting bolt and fastener to correct the glass position if the clearance between the glass and sash are not parallel.

    Other materials

    High Pressure Fuel Pump and Fuel Hose
    Exploded View CAUTION: Never remove or disassemble parts unless instructed as shown in the figure. High pressure fuel pump insulator High pressure fuel pump O-ring High pressure fuel pump lifter Bracket Holder Fuel feed hose         To fuel rail (bank 1). ...

    Rear Cooler Pipe Assembly
    Removal and Installation REMOVALCAUTION: Perform lubricant return operation before each refrigeration system disassembly. However, if a large amount of refrigerant or lubricant leak is detected, never perform lubricant return operation. Refer to Perform Lubricant Return Operation. When disconnec ...

    Front Foot Lamp
    Exploded View Front Foot Lamp (LH) Steering member assembly Front foot lamp bracket (LH) Front foot lamp (LH) : Pawl : vehicle front Front Foot Lamp (RH) Front foot lamp (RH) Front foot lamp bracket (RH) Passenger knee air bag module : Pawl : vehicle front ...