Exploded View

![]() |
Front height sensor | ||||
| :vehicle front | |||||
![]() |
:N·m (kg-m, ft-lb) | ||||
![]() |
:N·m (kg-m, in-lb) | ||||
Removal and Installation
REMOVAL
WARNING:
-
When removing the air suspension component parts, always follow the removing procedure since the vehicle height may accidentally drop and it can lead to personal injury.
CAUTION:
-
Never disassemble the front height sensor.
Start engine.
Turn auto height mode control switch to ON, shift the shift position to N and set to normal height.
Turn OFF the electronic air suspension function. Refer to Operation.
Stop engine.
Lift up the vehicle.
Disconnect front height sensor harness connector.
Remove front height sensor.
INSTALLATION
Note the following, and install in the reverse order of the removal.
-
Completely engage hooks on frame when installing front height sensor.

-
Perform inspection after installation. Refer to Inspection.
-
Perform adjustment after installation. Refer to Adjustment.
Inspection
INSPECTION AFTER INSTALLATION
-
Make sure the electronic air suspension function is turn ON. Refer to Operation.
-
Confirm that no warning message is displayed on the information display. Refer to Air suspension warning.
-
Perform the self-diagnosis using CONSULT. Check if any DTC is detected. Refer to CONSULT Function.
-
Confirm to close the hood.
Adjustment
ADJUSTMENT AFTER INSTALLATION
Perform the height sensor calibration. Refer to Work Support.
Other materials
Rear Evaporator
Removal and Installation
REMOVALRemove rear A/C unit assembly. Refer to Removal and Installation.
Remove rear heater core. Refer to Removal and Installation.
Remove rear mode door motor. Refer to Removal and Installation.
Remove sub harness from rear A/C unit case RH.
Disconnect rear blower motor ...
When Both Power Window Main Switch and Rear Power Window Switch Lh Are Operated
Diagnosis Procedure
CHECK REAR POWER WINDOW MOTOR LH POWER SUPPLY AND GROUND CIRCUIT
Check rear power window motor LH power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK ...
Drain Hose
Exploded View
Refer to Exploded View.
Removal and Installation
REMOVALFrontRemove headlining. Refer to Removal and Installation.
Remove instrument panel assembly. Refer to Removal and Installation.
Remove front drain hose from fixing clips.
Disconnect front drain hose from moonroof unit assembly and ...


