WARNING:
INSPECTION AFTER REMOVAL
Oil Cooler
Check oil cooler for cracks. Check oil cooler for clogging by blowing through engine coolant inlet. If necessary, replace oil cooler.
Relief Valve
Check relief valve with the following procedure.
Press steel ball of relief valve using a clean plastic stick. Check that valve moves smoothly and proper spring repulsion is felt.
Replace relief valve, if necessary, with the following procedure.
Remove the relief valve by prying using a screwdriver.
CAUTION:
Never damage the mounting hole.
Press in the relief valve until it reaches a depth of 7 mm (0.28 in) from end surface of oil pan (upper) using approximately 10 mm (0.39 in) diameter drift.
CAUTION:
Carefully press in the relief valve by aligning its mounting hole side with the axle center so as not to cause deformation.
INSPECTION AFTER INSTALLATION
Check the engine oil level and the engine coolant level and add engine oil and engine coolant. Refer to ENGINE COOLANT : Inspection and refer to Inspection.
Start the engine, and check there is no leakage of engine oil or engine coolant.
Stop the engine and wait for 10 minutes.
Check the engine oil level and the engine coolant level again. Refer to ENGINE COOLANT : Inspection and refer to Inspection.
Removal and InstallationExploded View
Roof rail cover rear Roof rail cover front Roof rail Roof rail bracket front Roof rail bracket center Roof rail bracket rear : Rivet : Clip : Pawl : Metal clip : Always replace after every disassembly ...
Exploded View
Front height sensor :Vehicle front :N·m (kg-m, ft-lb) :N·m (kg-m, in-lb) ...
Precautions for Removing Battery Terminal
With the adoption of Auto ACC function, ACC power is automatically supplied by operating the Intelligent Key or remote keyless entry or by opening/closing the driver side door. In addition, ACC power is supplied even after the ignition switch is turned to the OFF position, i.e. ACC power is supplied ...