Nissan Armada 2025-2026 Service and Repair Manual: Inspection
INSPECTION AFTER INSTALLATION
Check fluid leakage and the fluid level. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
When replacing transfer cam position sensor, performe writing unit parameter. Refer to Description.
Removal and Installation
WARNING:
REMOVAL
Ignition switch OFF.
CAUTION:
Wait for 60 seconds after the ignition switch OFF.
Disconnect negative battery terminal. Refer to Removal and Installation.
Disconnect the transfer cam ...
Air Breather
...
Other materials:
Disassembly and Assembly
CAUTION:
OUTSIDE SEAT CUSHION FINISHER OUTER
Disassembly
Disengage fixing pawls, and then remove reclining knob cap.
: Pawl
Disengage fixing portion using a remover tool (A) according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove reclining knob.
Remove ...
Symptom Table
Symptom Possible causeInspection itemSecond heated seat system does not operateDisplay unit and rear A/C control operation does not operateFuseSecond seat heater power supply/ground/LIN signal circuitSecond seat cushion heaterSecond seatback heaterA/C auto amp.
Check second seat heater
Refer to Comp ...
Inspection
INSPECTION AFTER REMOVAL
Check the oil seal assembled transfer control actuator for wear, crack and damage. Replace if there is malfunction.
Check the transfer assembly as follows.Install the suitable tool (A) to transfer assembly as shown in the figure.
When turn the shaft in direction , check re ...
0.0054