Nissan Armada 2025-2026 Service and Repair Manual: Inspection
WARNING:
COMPONENT PART
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to Wheel Bearing. Rotate wheel hub and make sure there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.
Other materials:
Normal Operating Condition
SHIPPING MODE
Shipping mode inhibits battery power consumption during transportation or storage of the vehicle. Vehicle is set to shipping mode before being shipped from the factory.
When ignition switch is OFF, BCM operates shipping mode.
For shipping mode cancel operation, refer to Work Procedure. ...
Exploded View
With ProPILOT Assist 2.1 models
Combination switch Steering angle sensor Spiral cable : Pawl
Without ProPILOT Assist 2.1 models
Combination switch Steering angle sensor Spiral cable : Pawl : Always replace after every disassembly. ...
ECM : Removal & Installation
CAUTION:
Perform ADDITIONAL SERVICE WHEN REPLACING ECM. Refer to Work Procedure.
REMOVAL
With ProPILOT Assist 2.1
Disconnect the ECM harness connectors.
Remove ECM mounting nuts ( ) and remove ECM from the bracket.
Remove bracket mounting nuts ( ) and remove the bracket .
Without ProPILOT Ass ...
0.0067