Nissan Armada 2025-2026 Service and Repair Manual: Inspection and Adjustment
INSPECTION BEFORE INSTALLATION
Be sure to check dimension (A) to ensure it is within the reference value limit.
| B | : Scale |
| C | : Straightedge |
| Dimension (A) | : Refer to Torque Converter. |
INSPECTION AFTER INSTALLATION
Start the engine and check visually that there is no leakage of ATF.
Check A/T position. Refer to Inspection.
ADJUSTMENT AFTER INSTALLATION
Adjust A/T fluid level. Refer to Adjustment.
When replaced A/T assembly, perform "ADDITIONAL SERVICE WHEN REPLACING TRANSMISSION ASSEMBLY". Refer to Description.
Removal and Installation
WARNING:
REMOVAL
CAUTION:
When removing the A/T assembly from engine, first remove the crankshaft position sensor (POS) from the A/T assembly.
Be careful not to damage sensor edge.
When replacing A/T ...
4wd
...
Other materials:
Work Procedure
When the following parts are replaced or removed, be sure to perform the specified incidental work in order to operate the system normally.
PREPARATION BEFORE CALIBRATION
Place the vehicle on a level surface.
Adjust all tire pressures to the specified pressure. Refer to TIRE AIR PRESSURE : Service D ...
Diagnosis Procedure
PERFORM SELF-DIAGNOSIS
With CONSULT
Pull the parking brake switch.
NOTE:
Check to make sure that the parking brake switch indicator is turned ON.
Ignition switch OFF.
Get out of the vehicle and close all doors.
Wait 65 seconds.
NOTE:
Check to make sure that the parking brake switch indicator is turn ...
ON BOARD DIAGNOSTIC (OBD) SYSTEM : Precautions
The ECM has an on board diagnostic system. It will illuminate the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.
CAUTION:
Always turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection work. The open ...
0.0055