Nissan Armada 2025-2026 Service and Repair Manual: Work Procedure
When the following parts are replaced or removed, be sure to perform the specified incidental work in order to operate the system normally.
PREPARATION BEFORE CALIBRATION
Place the vehicle on a level surface.
Adjust all tire pressures to the specified pressure. Refer to TIRE AIR PRESSURE : Service Data.
GO TO 2.
PERFORM CALIBRATION
With CONSULT
Start the engine.
Select "Work Support" in "HD MAP".
Select "HD map module calibration".
Select "START".
CAUTION:
Do not shake the vehicle while performing "HD map module calibration".
Is "Completed" message displayed?
YES>>WORK END
NO>>Perform steps 1 and 2 again.
Other materials:
Adjustment of Brake Caliper Initial Position
CAUTION:
When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "Initialization position adjustment" of "Work support". Refer to Work Procedure.
×: Required —: not required
Procedure Initialization position adjustme ...
Exploded View
Reservoir cap Electrical brake control unit Bracket Caution label Gasket Spacer : N·m (kg-m, ft-lb) : N·m (kg-m, in-lb) : Always replace after every disassembly. ...
Garage Jack and Safety Stand
WARNING:
CAUTION:
Place a wooden or rubber block between safety stand and vehicle body when the supporting body is flat.
Never place a jack on the cooling fin of rear final drive assembly.
Place a jack on the mating surface of rear final drive assembly and rear cover (rear side).
: Garage jack po ...
0.0057