SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing front door glass. Refer to Work Procedure.
FITTING INSPECTION
Check that glass is fitted securely into the sash groove.
Lower glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each fastener to correct the glass position if the clearance between the glass and sash are not parallel.
Removal and InstallationWiring Diagram
BATTERY POWER SUPPLY FUSE No. 27
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 30
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 55
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 58
Click link to Wiring Diagram.
BATTERY POWER SUPPLY FUSE No. 133
Click link to ...
Removal and Installation
REMOVAL
Remove automatic back door switch finisher. Refer to Removal and Installation.
Disengage automatic back door close switch assembly fixing pawls using a remover tool (A), and then remove automatic back door close switch assembly from automatic back door switch finisher.
: Pawl
INSTALLAT ...
Inspection
AFTER A COLLISION
WARNING:
To avoid the risk of death or severe injury:
Replace any seat belt assembly (including anchor bolts) if:
Anchor bolts are deformed or worn out.
PRELIMINARY CHECKS
Check the shoulder seat belt guide for second seat. Check that guide swivels freely and that webbing lays fla ...