Nissan Armada 2025-2026 Service and Repair Manual: Inspection and Adjustment
SYSTEM INITIALIZATION
Perform additional service for operating the power window control system normally after installing front door regulator. Refer to Work Procedure.
FITTING INSPECTION
Check that the glass is fitted securely into the sash groove.
Lower the glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. Loosen each mounting bolt and fastener to correct the glass position if the clearance between the glass and sash are not parallel.
Disassembly and Assembly
DISASSEMBLY
Remove front door module assembly. Refer to Removal and Installation.
Remove front door power window motor mounting bolts, and then remove front door power window motor.
ASSEMBLY
Note the ...
Other materials:
Refilling
WARNING:
The ignition switch OFF.
Recommended fluid and capacity: Refer to Fluids and Lubricants.
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specif ...
Exploded View
Circular clip Dust shield Housing Snap ring Ball cage/steel ball/inner race assembly Stopper ring Boot band Boot Shaft Joint sub-assembly : Wheel side 1: NISSAN genuine grease or an equivalent. 2: Apply paste [service parts (440037S000)]. : Always replace after every disassembly. ...
Exploded View
A/T assembly Oil pan gasket Overflow tube O-ring Oil pan Drain plug O-ring O-ring Refer to Removal and Installation. : Always replace after every disassembly. : Apply ATF ...
0.0052