Nissan Armada 2025-2026 Service and Repair Manual: Refilling
WARNING:
The ignition switch OFF.
| Recommended fluid and capacity: | Refer to Fluids and Lubricants. |
CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Install filler plug on transfer and tighten to the specified torque.
CAUTION:
Never reuse filler plug.
| Specified torque | : 37.5 N·m (3.8 kg-m, 28 ft-lb) |
Draining
WARNING:
The ignition switch OFF.
Remove the drain plug .
Drain transfer fluid.
Install drain plug to transfer and tighten to the specified torque.
CAUTION:
Never reuse drain plug.
Specified tor ...
Other materials:
Removal and Installation
REMOVAL
CAUTION:
Remove rear spoiler. Refer to Removal and Installation.
While pushing rear washer nozzle fixing pawl , remove rear washer nozzle with rear washer nozzle tube in the direction of the arrow in the figure.
Remove rear washer nozzle tube from rear washer nozzle.
Remove connector fro ...
Removal and Installation
REMOVAL
CAUTION:
Never use a material for remover tool which could damage body side panel.
Fully open front door and rear door.
Apply a protective tape (A) on the parts to protect it from damage.
Cut double-sided tapes using a remover tool (A) and cutter (B), and then remove parting seal C.
CAUT ...
Adjustment
PINION GEAR HEIGHT
If the hypoid gear set has been replaced, select the pinion height adjusting washer.
Use the formula below to calculate pinion height adjusting washer thickness.
Washer selection equation: T = T0 + (t1− t2) T: Correct washer thickness T0: Removed washer thickness t1: O ...
0.0051