Exploded View
 |
Back door panel |  |
License plate lamp | ||
 |
: Pawl | ||||
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
REMOVAL
Disengage license plate lamp fixing pawl according to numerical order 1→2 indicated by arrows as shown in the figure.
Disconnect license plate lamp harness connector, and then remove license plate lamp.
INSTALLATION
Connect license plate lamp harness connector.
Install license plate lamp fixing pawl according to numerical order 1→2 indicated by arrows as shown in the figure.
Replacement
CAUTION:
Disconnect battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
LICENSE PLATE LAMP
CAUTION:
Replacement of a single part is not possible because license plate lamp cannot disassemble. For replacement, replace license plate lamp as a set. Refer to Removal and Installation.
Other materials
Back Door Touch Sensor
Removal and Installation
REMOVALRemove back door inner finisher. Refer to Removal and Installation.
Disconnect back door touch sensor harness connector .
Remove back door touch sensor fixing clips.
: Clip
Remove harness grommet from back door panel, and then pull out back door touch sensor ...
Intelligent Rear View Mirror
Exploded View
Intelligent rear view mirror cover LH
Intelligent rear view mirror cover RH
Intelligent rear view mirror
Inside mirror base
: Pawl
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
Never move intelligent rear view mirror beyond t ...
Sonar Sensor (front)
Exploded View
CITY MODELS
Front bumper fascia
Corner sensor front LH holder
Corner sensor front LH
Center sensor front LH holder
Center sensor front LH
Center sensor front RH holder
Center sensor front RH
Corner sensor front RH
Corner sensor front RH holder
vehicle fro ...