Removal and Installation
REMOVAL
Remove back door inner finisher. Refer to Removal and Installation.
Disconnect back door touch sensor harness connector 
.
Remove back door touch sensor fixing clips.
 |
: Clip |
Remove harness grommet from back door panel, and then pull out back door touch sensor harness from back door panel and remove back door touch sensor.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
-
After installing, check that there is no clearance between back door touch sensor and back door panel.
-
After installation, check that back door turns over normally by back door touch sensor.
-
After installation, check door lock. Refer to Inspection.
Other materials
Water Pump
Exploded View
Water pump
Gasket
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
Removal & Installation
WARNING:
Jacking up or lift up the vehicle may the vehicle height to go down which cause a p ...
Back Pillar Garnish
Removal and Installation
CAUTION:
Never damage the body panel.REMOVALCAUTION:
When removing, always use a remover tool that is made of plastic to prevent damage to the parts.Remove roof rear garnish. Refer to Removal and Installation.
Release back pillar garnish portion of back door weather-strip. R ...
Diagnosis and Repair Workflow
Work Flow
OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM
Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs).
Check operation condition of the function that is malfunctioning.
>>
GO TO 2.
CHECK ...