Pantograph Jack
WARNING:
-
Jacking up or lifting up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System (With electronic air suspension).
-
When checking under the vehicle or inside wheel house, always turn OFF the electronic air suspension function with the vehicle unladen and normal height, since the suspension may accidentally move and it can lead to personal injury. Refer to Precaution for Electronic Air Suspension System (With electronic air suspension).
-
Never get under the vehicle while it is supported only by the jack. Always use safety stands to support the frame when you have to get under the vehicle.
-
Place wheel chocks at both front and back of the wheels on the ground.

Garage Jack and Safety Stand
WARNING:
CAUTION:
-
Place a wooden or rubber block between safety stand and vehicle body when the supporting body is flat.
-
Never place a jack on the cooling fin of rear final drive assembly.
-
Place a jack on the mating surface of rear final drive assembly and rear cover (rear side).

![]() |
: Garage jack point | ||||
![]() |
: Safety stand point | ||||
| : vehicle front | |||||
2-Pole Lift
WARNING:
-
When lifting the vehicle, open the lift arms as wide as possible and ensure that the front and rear of the vehicle are well balanced.
-
When setting the lift arm, never allow the arm to contact the brake tubes, brake cable, or fuel lines.

| : vehicle front | |||||
Other materials
STANDARD mode
The symbol of this Nissan Armada mode is
.
STANDARD mode is the default setting in the Nissan Armada and is optimized for
everyday driving. It provides a balanced combination of performance, comfort, and
efficiency suitable for most road conditions.
ECO mode
Basic information
The symbol of ...
Low Tire Pressure Warning Lamp Blinks
Description
When the ignition switch is placed ON, the low tire pressure warning lamp blinks. And then 1 minute later, low tire pressure warning lamp turns ON.
Diagnosis Procedure
CHECK TIRE PRESSURE SENSOR INSTALLATION
Check visually that tire pressure sensors are installed to each wheels correctl ...
Configuration (a/c Auto Amp.)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the A/C auto amp.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the vehicle speci ...

