Description
When replacing chassis control module, it is necessary to write MAC key to chassis control module. Write MAC key to chassis control module according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.
CAUTION:
During MAC key writing, maintain the following conditions:
-
Ignition switch ON
-
CONSULT is connected to internet
Work Procedure
PERFORM MAC KEY WRITING
-
Ignition switch ON.
-
Select "MAC Key writing" on "Work support" of "CHASSIS CONTROL" using CONSULT.
-
Touch "Write".
>>
WORK END
Other materials
Additional Service When Replacing Ecm
Description
When replacing ECM, the following procedure must be performed. (For details, refer to Work Procedure.)CAUTION:
When replacing the ECM, always replace it with a new one. The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another vehicle.PROGRAMM ...
Sub Woofer
Removal & Installation
REMOVALRemove luggage side lower finisher LH. Refer to Removal and Installation.
Remove sub woofer mounting nuts , and then remove sub woofer .
Disconnect sub woofer harness connector.INSTALLATIONInstall in the reverse order of removal. ...
Facial Recognition Check
Work Procedure
If system detects that driver is not facing forward even though driver is facing forward, perform face recognition check.PREPARATION BEFORE FACE RECOGNITION CHECK
Make sure that all of the following conditions are satisfied
vehicle speed is 0 km/h (stopped).
Shift position is "P" ...