Removal and Installation
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
REMOVAL
CAUTION:
-
Oil filter is provided with relief valve. Use genuine NISSAN oil filter or equivalent.
-
Never get burned when engine and engine oil may be hot.
-
When removing, prepare a shop cloth to absorb any engine oil leakage or spillage.
-
Never allow engine oil to adhere to drive belt.
-
Completely wipe off any engine oil that adheres to engine and vehicle.
NOTE:
Remove engine under cover using a power tool (commercial service tool). Refer to Removal and Installation.
Using oil filter wrench [SST: KV10115801 (NI-38956)] , remove oil filter
.

| : Engine front |
INSTALLATION
Remove foreign materials adhering to oil filter installation surface.
Apply engine oil to the oil seal contact surface of new oil filter.

Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn
. Or tighten to the specification.

| Oil filter: | |
: 17.7 N·m (1.8 kg-m, 13 ft-lb) |
|
Inspection
WARNING:
-
Jacking up or lift up the vehicle may the vehicle height to go down which cause a personal injury and/or damage to the air suspension component parts. Refer to Precaution for when Jacking and Lifting Up the vehicle with Electronic Air Suspension System.
INSPECTION AFTER INSTALLATION
Check the engine oil level. Refer to Inspection.
Start the engine, and check there is no leak of engine oil.
Stop the engine and wait for 10 minutes.
Check the engine oil level, and adjust the level. Refer to Inspection.
Other materials
Engine Lubrication System Service Data and Specifications
ENGINE OIL
ENGINE OIL CAPACITY (APPROXIMATE)Unit: (US qt, lmp qt) Drain and refill
With oil filter change
6.0 (6-3/8, 5-2/8)
Without oil filter change
5.6 (5-7/8, 4-7/8)
Dry engine (Overhaul)
7.2 (7-5/8, 6-3/8)
Engine Oil Pressure
Unit: kPa (kg/cm2, psi)
Engine speed
Approximate ...
Rear Door Hinge
Removal and Installation
REMOVALRemove rear door assembly. Refer to Removal and Installation.
Remove rear door hinge mounting bolts, and then remove rear door hinge from vehicle body.INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION:
Before installation ...
Front Wiper Arm
Removal and Installation
CAUTION:
Clean windshield glass and front wiper refill so that windshield glass may not be damaged by dust, etc. REMOVALOperate front wiper to the auto stop position. Refer to System Description.
Fully open hood assembly.
Remove front wiper arm cap.
Remove front wiper arm ...
: 17.7 N·m (1.8 kg-m, 13 ft-lb)